05:23:58 INFO Containerlab started version=0.68.0 05:23:58 INFO Parsing & checking topology file=clab.yml 05:23:58 INFO Removing directory path=/work/netlab_cicd/cisco/clab-ml_30 05:23:58 INFO Creating docker network name=nl_mgmt_30 IPv4 subnet=192.168.30.0/24 IPv6 subnet="" MTU=0 05:23:58 INFO Creating lab directory path=/work/netlab_cicd/cisco/clab-ml_30 05:23:58 INFO Creating container name=srv 05:23:58 INFO Creating container name=r1 05:23:58 INFO Creating container name=r2 05:23:58 INFO Creating container name=dut 05:23:59 INFO Created link: dut:eth1 (Ethernet0/1) ▪┄┄▪ r1:eth1 05:23:59 INFO Created link: dut:eth2 (Ethernet0/2) ▪┄┄▪ r2:eth1 05:23:59 INFO Created link: dut:eth3 (Ethernet0/3) ▪┄┄▪ srv:eth1 05:23:59 INFO Running postdeploy actions for Cisco IOL 'dut' node 05:23:59 INFO Adding host entries path=/etc/hosts 05:23:59 INFO Adding SSH config for nodes path=/etc/ssh/ssh_config.d/clab-ml_30.conf ╭────────────────┬──────────────────────────────┬─────────┬────────────────╮ │ Name │ Kind/Image │ State │ IPv4/6 Address │ ├────────────────┼──────────────────────────────┼─────────┼────────────────┤ │ clab-ml_30-dut │ cisco_iol │ running │ 192.168.30.101 │ │ │ vrnetlab/cisco_iol:17.15.01 │ │ N/A │ ├────────────────┼──────────────────────────────┼─────────┼────────────────┤ │ clab-ml_30-r1 │ linux │ running │ 192.168.30.102 │ │ │ quay.io/frrouting/frr:10.3.1 │ │ N/A │ ├────────────────┼──────────────────────────────┼─────────┼────────────────┤ │ clab-ml_30-r2 │ linux │ running │ 192.168.30.103 │ │ │ quay.io/frrouting/frr:10.3.1 │ │ N/A │ ├────────────────┼──────────────────────────────┼─────────┼────────────────┤ │ clab-ml_30-srv │ linux │ running │ 192.168.30.104 │ │ │ quay.io/frrouting/frr:10.3.1 │ │ N/A │ ╰────────────────┴──────────────────────────────┴─────────┴────────────────╯ Using transformed lab topology from snapshot file netlab.snapshot.yml Checking virtualization provider installation OK: clab installed and working correctly Starting clab nodes provider clab: executing sudo -E containerlab deploy --reconfigure -t clab.yml Initial configuration skipped, run 'netlab initial' to configure the devices