[r2_no_vrrp] Disable VRRP on R2 [ node(s): r2 ] [INFO] Executing configuration snippet ifdown [PASS] VRRP has been disabled on R2 [ping_vrrp_v4] Verify VRRP for IPv4 is enabled on DUT [ node(s): h1 ] [PASS] h1: Ping to ipv4 h2 (172.16.44.4) succeeded [PASS] Test succeeded in 0.1 seconds [ping_vrrp_v6] Verify VRRP for IPv6 is enabled on DUT [ node(s): h1 ] [PASS] h1: Ping to ipv6 h2 succeeded [PASS] Test succeeded in 0.1 seconds [r2_vrrp_up] Enable VRRP or R2 [ node(s): r2 ] [INFO] Executing configuration snippet ifdown [PASS] VRRP has been reenabled on R2 [r2_v4_backup] Verify that R2 is in the backup state for IPv4 [ node(s): r2 ] [PASS] Validation succeeded on r2 [PASS] Test succeeded in 0.1 seconds [r2_v6_backup] Verify that R2 is in the backup state for IPv6 [ node(s): r2 ] [PASS] Validation succeeded on r2 [PASS] Test succeeded in 0.1 seconds [r2_prio_high] Starting test [ node(s): r2 ] [INFO] Executing configuration snippet vrrp-priority [PASS] R2 VRRP priority has been increased to 80 [r2_v4_master] Verify that R2 took over as master on IPv4 (VRRP priority on DUT is lower than 80) [ node(s): r2 ] [PASS] Validation succeeded on r2 [PASS] Test succeeded in 3.8 seconds [r2_v6_master] Verify that R2 took over as master on IPv6 (VRRP priority on DUT is lower than 80) [ node(s): r2 ] [PASS] Validation succeeded on r2 [PASS] Test succeeded in 0.1 seconds [r2_prio_low] Starting test [ node(s): r2 ] [INFO] Executing configuration snippet vrrp-priority [PASS] R2 VRRP priority has been lowered to 20 [preempt_v4] Verify that DUT preempts R2 when its priority is lowered [ node(s): r2 ] [PASS] Validation succeeded on r2 [PASS] Test succeeded in 2.9 seconds [preempt_v6] Verify that DUT preempts R2 when its priority is lowered [ node(s): r2 ] [PASS] Validation succeeded on r2 [PASS] Test succeeded in 0.1 seconds [SUCCESS] Tests passed: 12